Synergy 8009-30 - Jeep JK Front Axle Outer Shell Kit - Manual (Page 16)

23. Align and weld coil spring mounts. Prep the coil spring mounts to weld to the axle
tube, grind the cut edge smooth so it fits the axle tube well. Also remove the paint
from the side adjacent to the cut edge where you will be welding. Position the coil
spring mount on the side they were removed from. The outside edge of the coil
spring mount should go against the inside edge of the shock bracket as shown. The
outer edge of the coil spring mount should be about 1 ½” from the reference location
on the inner C.
Place your angle finder on top of the coil spring mount; the coil spring mount should
angle 1.5 degrees back.