Synergy 5013 - Jeep JK Rear Coilover Kit - Manual (Page 6)

8) Do one side at a time, so that measurements can be taken from the factory mounts on
the opposing side. Begin by cutting off the factory LCA brackets. Cut at the base of
the weld on the bracket side as to prevent cutting into the axle tube. Once bracket is
removed, grind the axle tube smooth. A 4 ½” angle grinder works well for this.
9) Next, tack the new 8072 bracket onto the axle tube, they are L&R specific and should
point inwards toward the center of the vehicle.
§ Measure the distance from the bearing flange on the housing to the
factory LCA brkt as a reference, approximately 3in. Also, place an
angle finder on the back of the factory brkt and match the angle
when tacking on the new one.