Lukas P 660 SG - Manual (Page 20)

20
11.2 Preventative service
11.2.1 Care instructions
The exterior of the device needs to be cleaned from time to time and the metallic surfaces
need to be rubbed with oil to protect against corrosion.
11.2.2 Function and stress test
If there are doubts about safety or reliability, a function and stress test needs to be performed.
LUKAS offers the appropriate test equipment.
11. Repairs
11.1 General
Service work may only be performed by the device manufacturer or by personnel trained by
the device manufacturer and authorized LUKAS dealers.
For all components, only original LUKAS replacement parts may be supplied in exchange,
as are listed in the spare parts list, because in this way also any required special tools,
assembly instructions, safety aspects, tests absolutely must be taken into consideration (see
also the chapter "Care and maintenance" for more information).
During the assembly work, pay particular attention to the cleanliness of all components
because dirt can damage the rescue equipment!
WARNING / CAUTION / ATTENTION!
Wear protective clothing when making repairs because the devices may be
under pressure even in the idle state.
NOTE:
Always send the warranty tab back to LUKAS hydraulics GmbH. Only in this way
will you have a claim to the extended warranty coverage.
ATTENTION!
Because LUKAS hydraulic units are designed for the highest performance,
only components may be replaced that are listed in the spare parts lists of the
corresponding unit.
Additional components of the units may only be replaced if:
- You have participated in a corresponding LUKAS service training course.
- You have the express permission of LUKAS customer service (by request,
check on the grant of permission. A check is necessary in each individual
case!).
NOTE:
Do not perform any repairs without the corresponding LUKAS spare parts list,
because necessary tightening torques for screw connections and/or in some
cases also important additional information are listed there.
ATTENTION!
Ensure that no fuel can escape during the repair work on the units!