Lukas P 660 SG - Manual (Page 11)

11
NOTE:
We recommend, when ambient temperatures are low and extension hoses /
hose reels are used, connecting the coupling halves in a depressurised state
because decoupling may otherwise require a very large exertion of force.
For dust protection, the supplied dust caps must be reattached.
WARNING / CAUTION / ATTENTION!
The monocouplings must not be unscrewed and/or the hose lines reversed!
7. Installation and commissioning
7.1 Installation
WARNING / CAUTION / ATTENTION!
Due to the possibility of spark formation, combustion engine units must not be
used in areas at risk for explosion.
No units containing combustion engines may be used in closed rooms due to
risk of poisoning and/or suffocation!
The unit should be installed at a suitable site (secure location / À at surface / suf¿ cient distance
from vehicles, loads, ignition sources, etc.).
In order to ensure maximum safety and À uid withdrawal quantities, you should operate the
unit in a horizontal position to the extent possible.
7.2 Commissioning
For commissioning, you should proceed in the following way:
1. First, check the À uid levels of the unit. To do so, the unit must sit horizontally on a stable
and À at surface and the motor must be switched off.
Procedure for motor oil level:
a) Remove the oil ¿ ller cap and check the oil level of
the motor (see ¿ gure on right).
b) If the oil level is below the lowest level, suitable
oil (refer to chapter "Motor oil recommendations")
must be replenished to the upper mark. When
checking the oil level, do not turn the oil ¿ ller cap.
c) Change the oil when the oil is dirty. (refer to chapter
"Repairs") MIN.
MAX.
MIN. MAX.