Lukas P 660 SG - Manual (Page 15)

15
NOTE:
If the motor does not start even after
several attempts, repeat the procedure
described above with the motor switch
in position " " (RUN).
6. After a warm-up phase of 20 to 30 seconds, set the motor switch to position
" " (RUN).
3. Set the motor switch to position " " (CHOKE)
(if the motor is warm, or the ambient temperature
is
high, start the motor with the switch in position
" " (RUN)).
4. Slowly pull the handle of the recoil starter until it
has crossed the compression point (resistance
becomes noticeable), allow it to return to the basic
position and then pull it through swiftly.
5. After starting, allow the starter handle to return to
the basic position, while you continue to hold it in
your hand.