Lukas P 660 SG - Manual (Page 10)

10
5.6 Connection options
The connections for the hydraulic hoses are always provided on the unit.
The unit is provided exclusively with monocouplings.
6. Connection of the hose lines
ATTENTION!
When connecting the hose lines, make sure that the connection components are
not dirty and if necessary clean immediately beforehand!
The hydraulic hoses are connected via quick-disconnect coupling halves (female and male)
to the hydraulic pump in such a way that they cannot be reversed.
Male coupling Female coupling
Dust caps
Before coupling, remove dust caps, then connect male and female couplings and turn
locking sleeve of the female coupling in direction "1" until the locking sleeve engages. The
connection is then made and secured. The decoupling is accomplished by turning the locking
sleeve in direction "0".
The coupling of the devices under pressure is also possible, assuming the connected
equipment is not turned on.
WARNING / CAUTION / ATTENTION!
Before connecting devices, make sure that all components
used are suitable for the maximum operating pressure of the
hydraulic unit! In case of doubts, LUKAS must be consulted
directly before connecting the devices!
ATTENTION!
Only devices in the basic position may be connected to the unit in order to avoid
that an amount of hydraulic À uid greater than the maximum ¿ ll quantity can enter
the tank of the unit!