Lukas P 630 SG - Manual (Page 38)

38
Fault Check Cause Solution
It is frequently not
possible to couple
hose assemblies Hydraulic
À uid not
adapted to the
application situation
Hydraulic
À uid must be
replaced (see chapter
"Recommended
hydraulic
À uids")
Coupling defective Coupling must be
replaced immediately
Leak in the couplings Coupling defective Coupling must be
replaced immediately
Leakage at the drive
shaft of the hydraulic
pump Shaft seal defective. Repair by an
authorised dealer, by
personnel specially
trained by LUKAS, or
by LUKAS itself
Contact an authorised LUKAS dealer or the LUKAS Customer Service Department directly
if the malfunctions cannot be recti
¿ ed.
The address for the LUKAS Customer Service department is:
LUKAS
Hydraulik GmbH
A Unit of IDEX Corporation
Weinstraße 39, D-91058 Erlangen
Tel.: (+49) 09131 / 698 - 348
Fax.: (+49) 09131 / 698 - 353
NOTE:
In case of faults which affect the combustion engine, please also observe the instructions
in the separate operating instructions of the engine manufacturer.