Lukas P 630 SG User Manual
Page 28
28
A
B
5. Pour the new hydraulic
À uid through the ¿ ller neck into the hydraulic tank and close the
neck again with
¿ ller cap "B".
6. The unit then has to be bled again as described in the Chapter "Commissioning".
Replacing the hydraulic fl uid - procedure:
1. Place the power unit on a slightly elevated base so that the drain plug for the hydraulic
À uid can be easily reached.
2. Place a suitable collection container under the "A" drain plug.
3. Open the "B"
¿ ller cap, remove the "A" drain plug and let the hydraulic À uid run into the
provided collection container.
4. Screw the "A" drain plug in again (tightening torque max. 5 Nm).
11.2.4 Changing
decals
All damaged and/or illegible decals (safety notices, type plate etc.) must be replaced.
Procedure:
1. Remove damaged and/or illegible decals.
2. Clean surfaces with industrial alcohol.
3. Af
¿ x new decals.
Take care to af
¿ x the decals in the correct positions. If this is no longer known, you should
ask your authorised LUKAS dealer or contact LUKAS directly.