Service – Bunn AFPO-3 SL User Manual
Page 9
9
FLA
VOR
INP
UT
1
2
WA
TER
INP
UT
REF
ILL
MA
IN
PO
WE
R
2
1
1
2
3
3
3
FLA
VO
R
OU
TPU
T
FLA
VO
R
OU
TPU
T
WA
TER
OU
TPU
T
FLA
VO
R
OU
TPU
T
WA
TER
OU
TPU
T
WA
TER
OU
TPU
T
SERVICE
This section provides procedures for testing
and replacing various major components used in this
dispenser should service become necessary. Refer
to Troubleshooting for assistance in determining the
cause of any problem.
WARNING - Inspection, testing, and repair of electri-
cal equipment should be performed only by qualified
service personnel. The dispenser should be unplugged
when servicing, except when electrical tests are re-
quired and the test procedure specifically states to
plug in the dispenser.
COMPONENT ACCESS
WARNING - Disconnect the dispenser from the power
source before the removal of any panel or the replace-
ment of any component.
All components are accessible by removing the
eight #8-32 screws (five on the front and three on the
rear) securing the main housing to the main mounting
panel and the removal of the four #8-32 nuts secur-
ing the pump/solenoid switch panel to the solenoid
mounting bracket. Refer to Fig. 1
FIG. 1 COMPONENT ACCESS
P1521
41093 040408