beautypg.com

Bunn FMD-2 User Manual

Bunn Water equipment

background image

4. Twist the Whipper

Chamber clockwise and

pull it off the Whipper

Chamber Receptacle.

5. Pull the Frother off

the Motor Shaft. Notice

the flat keyway on the

shaft and the matching

keyway inside the Frother.

It is important that these

two keyways are lined up

when reassembling.

6. Twist Whipper Cham-

ber Receptacle clockwise

and pull it off the Motor

Shaft.

8. Wash components in

a mild solution of dish

detergent using a bristle

brush. Rinse and dry each

item thoroughly before

reassembling.

CLEANING INSTRUCTIONS for FMD-2 & 3 POWDER MIX DISPENSERS

NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!

RECOMMENDED DAILY CLEANING

1. Open the Cabinet

Door.

3. Pull the Mixing Cham-

ber out of the Whipper

Chamber.

7. Slip the O-ring off the

Whipper Chamber Re-

ceptacle and remove the

shaft seal.

35112.0000B 11/04 ©2002 Bunn-O-Matic Corporation

2. Remove the steam

collector by pulling it for-

ward and twisting in a

clockwise rotation.

DISASSEMBLY & CLEANING THE WHIPPER CHAMBERS (Once a week)

1. Empty the Drip Tray

and wash components

in a mild solution of dish

detergent using a bristle

brush. Rinse and dry each

item thoroughly before

reassembling.

3. Remove Hoppers and

refill with product.

2. Rinse out the Whipper

Chambers by placing the

RINSE/RUN switch in

the RINSE position and

activating the DISPENSE

switch for 5 to 10 second

bursts.