Apple Newton Utilities - Manual (Page 5)

L L L L L L L L L L L L L L L L L L L L L L
L L L L L L L L L L L L L L L L L L L L L L
L
2
Newton Utilities comes on a floppy disk. To install it on your
Newton device, you need a Macintosh or Windows-based
computer and the Newton Connection Kit.
If you need more information than is given in these
instructions, see the documentation that came with your
Newton device, your computer, and your Newton
Connection Kit.
Important
The Newton Utilities packages can be installed
either in memory or on a storage card. However, to get the
most out of Newton Utilities, it is recommended that you
install Software Manager and One Tap in memory. The
installed packages are compressed and take up minimal
space in your Newton device’s memory.
To install Newton Utilities, follow these steps:
1 Insert the floppy disk into a disk drive.
2 Copy the contents of the floppy disk to your computer’s
hard disk.
3 Connect your Newton device to your computer using the
cable that came with your Newton Connection Kit.
4 On your computer, open Newton Connection.
5 On your Newton device, tap Extras ´ to open the Extras
Drawer.
6 Tap Card B.
Chapter 2
Installing Newton Utilities