Belkin Omniview SMB KVM-over-IP Switch F1DP108G - Manual (Page 45)

42
Remote Installation
Restore Factory Settings
You can restore the Switch to its original factory settings. This restores the
original parameters, resetting all the information added by the administrators,
including: network settings, servers, switches, users, and passwords. You also
have the option to preserve network settings, as explained below.
WARNING! Once data has been reset, it cannot be retrieved.
To restore factory settings:
1.
Select “Restore Factory Settings” in the far-left menu. The
Restore-Factory-Settings page will appear (see Fig. 9).
2. Check the Preserve-Network-Settings box if you would like to preserve the
network settings.
3. Click .
Fig. 9 Restore-Factory-Settings Page
Logging Out
To exit the Configuration page and close the session, click .
Only one administrator can log into the Configuration area at a time. An idle
timeout of 30 minutes terminates the session.