Apple Xserve (Original) - Manual (Page 51)

Installing or Replacing Server Components 51
2 Remove the blank drive module or the drive currently installed.
m If there is no drive installed, press the handle on the front of the blank drive module so
that the handle pops out, then pull the blank drive module out of the front panel.
m If there is a drive module already in the bay:
a Make sure the drive currently in the bay is not being used by any application and that
the drive is not being shared by the server. (See the Mac OS X Server documentation
for information about shared drives.)
b Press the handle on the front of the drive module so that the handle pops out.
Remove the blank
drive module from the bay.
When pressed, the drive
module handle pops out.