Apple Xserve (Original) - Manual (Page 42)

42 Chapter 3
6 Attach the power cord’s retainer clip to the back panel to keep the power cord in place when
you open the server.
The ends of the clip fit into the small openings at either side of the power socket. Be sure
that the rounded part of the clip goes under the cord, so that the cord is supported.
If more than one power cord came with your server, use the appropriate cord for the
electrical service available at your location.
You can use the long power cord supplied with the server, or another cord, such as one
already installed in the rack.
7 If you will be using the FireWire port on the front panel of the server, connect a cable to it.
8 When all cables are in place, connect each one to its intended device.
Attach the power cord
retainer clip to the two
loops on the back of
the server. Snap the
cord into the clip so that
it cradles the cord.
Important
When connecting peripheral devices, be sure to allow adequate space at the
front and back of the server for proper airflow and access to the rack for servicing.