Apple Xserve (Original) - Manual (Page 38)

38 Chapter 3
1 Attach the small L-shaped brackets to the sides of the server enclosure’s cover with four of
the screws provided.
Orient the bracket so that the screws are at the top. Attach the brackets to holes that are
about one-third of the way back from the front panel.
2 Position the cover in the rack at the desired location and screw the flange of the L-shaped
bracket to the front of the rack on each side.
Be careful not to overtighten the flange screws. Doing so could change the shape of the
cover slightly and make it difficult to slide the server into the cover.
Attach the two telco mounting brackets to the server’s cover
using the four screws provided.
Important Be sure to work with another person for this part of the installation. The cover
should be held level to avoid changing its shape before the screws are inserted to hold it
in place.
Attach the cover to
the telco rack mounting
posts using four of the
screws provided.