Apple Power Macintosh 5260 Series - Manual (Page 98)

If the hard disk you want to initialize is not the startup disk, you can use the
Drive Setup program to initialize it. Drive Setup is located on the floppy disk
labeled Disk Tools that came with your computer. If your computer came with
a CD-ROM drive and you didn’t receive floppy disks, you can find Drive
Setup on the CD-ROM disc that contains system software. For instructions,
start Drive Setup and choose Drive Setup Guide from the Guide (h) menu.
If the hard disk you want to initialize is the startup disk, follow the
instructions in this chapter. (First, start up from a CD-ROM disc or a floppy
disk. Then follow the instructions in “How to Initialize a Hard Disk” later in
this section.)
Starting up from a CD-ROM disc
To initialize, test, or repair a hard disk, or to install system software on a hard
disk, you need to start up your computer from another disk. If your computer
has a CD-ROM drive, you can start up your computer using the CD-ROM
disc containing system software that came with the computer.
To start up the computer using the CD-ROM disc, follow these steps:
1 Turn your computer on.
2 When you see the desktop on your screen, press the Open/Close button on your
CD-ROM drive, and insert the CD-ROM disc containing system software into the drive.
3 Hold down the “c” key on your keyboard and restart your computer.
Continue to hold down the key until you see the “Welcome to Macintosh”
message.
WARNING Initializing a disk erases any information that may be on it.
Before you initialize a damaged disk, try to repair it as described in
“Repairing a Damaged Disk” later in this chapter.
96 Chapter 6