Apple Power Macintosh 5260 Series - Manual (Page 85)

You can’t open a document, or you see a message that an application program can’t
be found.
m Some documents can be opened by more than one application program.
Try starting a program that you think might be able to open the document,
then choose Open from the program’s File menu to try to open the
document.
m Purchase and install the correct software to use the document, or find out
if the creator of the document can convert it to a form that one of your
programs can use.
m Don’t try to open the files in your System Folder. Most of the files in your
System Folder are used by your computer for internal purposes and are not
intended to be opened.
m Rebuild your desktop (refer to “Rebuild Your Desktop” in the section “If
You Have Trouble” earlier in this chapter).
m If the document is from a DOS computer, use the PC Exchange control
panel to specify which Macintosh program will open the document. For
information about working with DOS documents on your Macintosh, see
the information about using DOS files in Macintosh Guide, available in the
Guide (h) menu.
You experience problems using a document from a DOS computer.
If you can’t open a DOS document using a Macintosh program, try the
following:
m Open the document from within the program by choosing Open in the
program’s File menu.
m Use the PC Exchange control panel to change the document’s type to one
that can be opened by the program.
If a DOS document is displayed incorrectly, or you see strange codes or
characters in the document, try one of the following:
m Your application program may have special procedures for opening and
saving documents with different file formats. See the information that
came with your program.
m Try opening the document in another program.
83 Troubleshooting