Apple Workgroup Server 8150/110 - Manual (Page 84)

About using the Installer program
Before you use the Installer, you need to start up your server by following the
instructions in either “Starting Up From the CD-ROM Drive” or “Starting Up
From the Floppy Drive” earlier in this chapter.
How you start using the Installer depends upon where it is located:
m If you started up from the Workgroup Server Software CD-ROM disc, open
the folder named System Software Installers and review the instructions in
the Read Me file before using the Installer programs there.
m If you started up from the floppy disk named Install Me First, the Installer
opens automatically. Depending on the version of system software on the
floppy disk, you may also need to use another Installer to do a system
update after the basic system installation.
After you open the Installer, using it to install system software involves the
following steps:
1 In the Welcome dialog box that appears, click Continue.
The version of system software you install may be later than the one shown in
this example.
68 Chapter 6 / Troubleshooting