AEM 30-2710 Peak & Hold Injector Driver 10 Channel - Manual (Page 3)

• A poor ground connection is the leading cause of ignition problems.
• Connect ground wires directly to the negative (-) battery terminal or engine block.
• There must be a ground strap connecting the engine to the chassis.
• If connecting a ground to the engine block, ensure it is a clean, paint free metal
surface.
There are 2 connectors on the end of the case:
GREY Connector (INPUT)
#
Name Color Function
1. Inj 1 In Pink Inj 1 Trigger input
2. Inj 2 In Brown Inj 2 Trigger input
3. Inj 3 In Orange Inj 3 Trigger input
4. Inj 4 In Dark Green Inj 4 Trigger input
5. Inj 5 In Grey Inj 5 Trigger input
6. Inj 6 In Dark Blue Inj 6 Trigger input
7. Inj 7 In Violet Inj 7 Trigger input
8. Inj 8 In Tan Inj 8 Trigger input
9. Inj 9 In Yellow Inj 9 Trigger input
10. Inj 10 In Light Green Inj 10 Trigger input
11. Ground Black Ground In, Connect to the Battery (-)
12. Ground Black Ground In, Connect to the Battery (-)
BLACK Connector (OUTPUT)
#
Name Color Function
1. Inj 1 Out Pink Inj 1 Output, connect 12V to other side of injector.
2. Inj 2 Out Brown Inj 2 Output, connect 12V to other side of injector.
3. Inj 3 Out Orange Inj 3 Output, connect 12V to other side of injector.
4. Inj 4 Out Dark Green Inj 4 Output, connect 12V to other side of injector.
5. Inj 5 Out Grey Inj 5 Output, connect 12V to other side of injector.
6. Inj 6 Out Dark Blue Inj 6 Output, connect 12V to other side of injector.
7. Inj 7 Out Violet Inj 7 Output, connect 12V to other side of injector.
8. Inj 8 Out Tan Inj 8 Output, connect 12V to other side of injector.
9. Inj 9 Out Yellow Inj 9 Output, connect 12V to other side of injector.
10. Inj 10 Out Light Green Inj 10 Output, connect 12V to other side of injector.
11. Pos 12V Red +12v in, Connect via fuse to ignition switch.
12. Pos 12V Red +12v in, Connect via fuse to ignition switch.