J.P. Instruments EDM 760 Pilots Guide - Manual (Page 42)

T, A OAT 0  OAT-I0 
OAT I0 
This step will be normally be skipped.
See step above.
Adjust the indicated temperature up
or down by up to 10°. For example,
OAT 3
 adjust the OAT upward 3°.
T, A EGT -
I?N EGT I?
N EGT 
I?Y
Y—Yes—sets the digital display to
one degree resolution; N—No—sets
10°. (10° is easier to see.)
F, A 29.00
= KF
LFT
05.00 
99.99
Used to set and fine tune the K
factor. See text below.
F, A KF =
29.00
RT
05.00 
99.99
Used to set and fine tune the K
factor. See text below.
F, A ACCU
M?N
USD
ACCU
M?N

ACCU
M?Y
N—No—Upon informing the EDM-
760 that you refueled the aircraft,
reset total fuel used to 0.
Y—Yes—accumulate total fuel used
rather than reset to 0.
F, A GPS-C
=
2
TO
GPS
0 5  GPS Com Format.
T, F, A DUMP?
N
MEM N NEW 
ALL  
Select to transfers ALL or only NEW
data. (Next step is bypassed for a
Long Term Memory DUMP.)
T, F, A END
Y END
Y 
END
N
Y—Yes to exit; N—No to review list
again.
Using a Factory Original TIT Probe
If your aircraft is using the factory original TIT probe and gauge, you will
be required to calibrate the EDM-760 for that probe. The factory original
Page 38 Engine Data Management