PureFlow AirDog FP-150 - 6.4L Ford 2008-2010 - Manual (Page 11)

11
AirDog
®
FP-100 & FP-150 Ford PowerStroke 2008 6.4L
Section 5-A Fuel Lines
AirDog
®
II Fuel Line to the Engine.
5A-1. Disconnect the fuel supply line to the engine from the OE fuel pump. This pump is
located on the driver’s side inside frame rail.
Fuel Pump with 1/2” Quick Connect Fitting
To Engine
Figure 14 DISCONNECT HERE Figure 15
View from Front View From Below
5A-2 Insert the female quick connect end (see figure 16) of the “pressure hose
assembly” into the male quick connect fitting previously installed in the port
marked “ENGINE”. You will hear a “click” when it connects.
Figure 16
5A-3. Connect the other end of the “Pressure Hose Assembly” (Figure 17) to
The original factory engine supply line shown in figures 14 & 15. It will “click” when
properly connected.
Figure 17
5A-4 Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.