PureFlow AirDog Dodge In-Tank Modification Kit User Manual
Page 7
7
INSTALLING THE PUREFLOW® FUEL MODULE UPGRADE
FOR FUEL MODULE WITHOUT THE IN-TANK PUMP
Note: The sending unit pictured may not be the exact same as the one you have, however
installation procedure will be similar on all sending units
Step 1. Drill two ½” fuel ports in the side of the fuel basket, across from each other, about 3 inches
from the bottom to allow more fuel into the basket.(see fig 1)
Figure 1
Figure 2
NOTE: The new ½” pickup tube assembly can be installed in fuel module through the opening with
the grommet.
If you do not have a hole already in the module, then you will need to drill a
hole in the module and follow the previous instructions for drilling the top of the module.
Step 2. Install the ½” quick connect fitting into bulkhead fitting. Use diesel compatible thread sealant
tape on the NPT threads.
Figure 3 Figure 4
DRILL 2 FUEL PORTS
VERY IMPORTANT