PureFlow AirDog Dodge In-Tank Modification Kit - Manual (Page 4)

4
An alternate method is to cut the black plastic supports (there are 3) around the top of the pump that
are attached to the basket and remove entire assembly, the end result will look like fig 9. This will
expose a small rubber valve at bottom of module (fig 8) that will allow fuel to enter module from
below.
Note: Drill a ½” hole in the sides of the bucket 2-3” from the bottom.
Figure 8 Figure 9
Step 4. Use supplied bracket as a template to mark two holes on the side of module, drill holes with a
3/16 bit being careful when drilling as the plastic can be brittle.
Slip the two wire clamp over the end of bracket and inset Nylon tube into bracket through the two
wire clamp (fig 8). Attach bracket with the supplied screws and lock nuts, slide tube down to the
bottom of module (fig 9). Connect the convoluted Teflon tube to the hard nylon tube securing with 2
spring clamps 180 degrees apart as in fig 9a.
Figure 9a