PureFlow AirDog Dodge In-Tank Modification Kit - Manual (Page 10)

10
Step 8. Slide the soft pickup tube assembly onto the bulkhead fitting and fasten with supplied spring
clamps as shown. Next, route soft plastic tube to bottom of module.
Step 9. Remove OE components from bottom of module basket, remove top screen (fig 10) but leave
bottom screen intact. Drill out center hole to at least 5/8” to allow hard Nylon tube to pass through
hole.
Figure 10
Step 10. Position angle bracket in module, use as template to drill two holes in a vertical pattern in the
side of module basket
.
It is not necessary to mount L bracket exactly as pictured, some modules will only allow bracket
to mount L shape up. Example: