PureFlow AirDog Dodge In-Tank Modification Kit - Manual (Page 5)

5
Step 5. Install the ½” quick connect fitting into the bulkhead fitting (fig 10). Use diesel compatible
thread sealant tape on the NPT threads (arrow shows where).
Figure 10 Figure 11 Figure 11A
Step 6.Insert the bulkhead fitting with the washer, o-ring side down, into the 5/8” hole.
Figure 12 Figure 13
Step 7. Install the washer and lock nut on the bulkhead fitting and tighten down onto the module (fig
12, washer not shown).