SkyTrak 6036 Tier II Operation Manual - Manual (Page 41)

Operation
35 Model 6036
Instrument Cluster Light Test
Test the bulbs in the instrument cluster before starting the engine.
Turn the ignition switch to the RUN position, ALL nine lights in the
instrument cluster will come ON for a few seconds and then go out. Replace
any bulbs that DO NOT come ON during this test. These lights will warn the
operator if an abnormal condition should arise during operation and will also
inform the operator when the road lights are on high beam or the turn
signals are activated.
Position of corresponding lights:
• Alternator Charging Light (3)
• Park Brake Light (4)
• Engine Oil Pressure Light (5)
• Engine Coolant Temperature Light (6)
• Hydraulic Tank Temperature Light (7)
• Transmission Temperature Light (8)
• High Beam Light (9)
• Not Used (10)
• Turn Signal Light (11)
0000 00
P
OH1810
(3)
(4) (5)
(6) (7)
(8) (9)
(10) (11)