SkyTrak 6036 Tier II Operation Manual - Manual (Page 123)

General Maintenance
117 Model 6036
B. Oil And Filter Change
(First 50 Hours)
(250 Hour Intervals)
1. Operate the engine until
warm (approximately 5
minutes).
2. Level the vehicle, ground
the carriage, place the travel select lever in (N) NEUTRAL, move
neutral lock lever to NEUTRAL LOCK position, engage the parking
brake switch and shut off the engine.
3. Place receptacle under engine oil pan drain.
4. Remove drain plug (4) from engine oil pan.
5. Allow oil to drain completely into a receptacle. Transfer the oil to a
container with a cover and label the container as used oil. Dispose
of the used oil at an approved recycling facility.
6. Unlock and open the left engine access door. Remove oil filter (5).
A strap or chain filter wrench may be required.
7. Clean filter sealing surface. Make sure the o-ring seal from the filter
comes off the sealing surface.
50
250
OS0830
OH2670
OH2710
OA1730
5