Defi ADVANCE Control Unit (DF07701 Manufactured in and before December, 2011) User Manual

Page 4

install the unit where it could fall. Improper installation or operation could
cause the product to fall and damage the vehicle or cause serious danger
by impeding driving.

Do not disassemble or modify this product. Such actions can

not only damage or destroy the product but also will void the
warranty.

Do not perform installation of this product immediately after the engine has

been switched off. The engine and exhaust system are extremely hot at this
time and can cause burns if touched.

Ensure that the wiring of this product does not have an adverse impact on

the other wiring of the vehicle. Before tapping speed or engine rev signal
from the ECU, please make sure that you have connected power cables
inside power supply wire properly. Then confirm that the DC Source LED
is lighted with ignition on. If it is functioning normally, remove negative
terminal connector from battery and go ahead with wiring procedure.
Incorrect wiring may destroy your ECU, ignition system and other engine
management devices.

Discontinue use of this product if the product doesn't operate or operates

improperly. Continued use while the condition exists could result in an ac-
cident or damage.

Please keep children and infants away from the installation area. Children

may swallow small parts or be injured in other ways.

Do not install this product in the area where safety equipment such as air

bags are mounted. This may cause more injuries in the event of accident.

Caution

This product is designed for use on 12V vehicles. Do not install

this product on vehicles with 24V systems.

Insulate any unused wires. If any wires or connectors loosen during installa-

tion, please make sure they are correctly reattached.

Do not drop any of the components of this product. It may result in dam-

age to the product.

Do not apply excessive force on switches/terminals. It may result in dam-

age to the product.

Disassemble/

Modify

24V

Do not use wires other than the provided wires.
Do not attach wires on the body of the vehicle or engine parts as this may

result in damage to the product.

Install wires away from ignition and also radio signal frequency interference

as this could cause the gauges to malfunction.

Please set it up so that the equipment such as the wireless machines and

cellular phones that emit electric waves should not touch the unit. It may
result in incorrect operation.

Do not place wires near the engine, exhaust pipe or turbine. It may result in

damage or fusion of wires.

Make sure the waterproof processing is done when diverging wires in the

engine compartment.

Do not lay the gauge face down due to oil leakage.

Angle "A" must be more than 90 degrees.

When installing the sensor, do not bend the wire near the sensor body.

Wear gloves to avoid burns when soldering and cuts when installing wires,

sharp edges of parts.

Do not expose the unit to moisture, dust or direct sunlight, or place product

directly in front of heat vents.

Install sensors away from hot or wet places.

When using sunshade, put sunshade between products and windshield to
avoid direct sun exposure .

Use the dried soft cloth for cleanup. Do not use the cleaner except for the

neutral detergent. It results in trouble.

Do not pull the wires out of connectors forcefully. The

connectors may be broken and the wires may be cut.
When pulling out the wires, press the lock firmly to unclip
the locks of connectors.

Do not install gauges, including this product, into the passenger side or

center of the dashboard. It doesn't meet vehicle safety standards.

Confirmation

Be sure to follow all instructions in this manual to ensure safe installation

and operation of the product.

Over 90°