Defi ADVANCE Control Unit (DF07701 Manufactured in and before December, 2011) User Manual

Page 14

vehicle illumination is on. (Illumination cancel)

【ADVANCE BF gauges】

The brightness of gauge illumination can be adjusted by pressing

button during Real mode, Record mode, or Playback mode.

Five levels of brightness are provided for daytime and nighttime separately.
The brightness level is shifted from daytime level to nighttime level being
interlocked with the vehicle illumination switch.

By pressing

button several times during Real mode, Record

mode or Playback mode, the gauge illumination is shifted to the maximum
brightness level even if the vehicle illumination is on. (Illumination cancel)

【ADVANCE ZD】

A dimming sensor is equipped with ZD. For brightness adjustment, either
AUTO or MANUAL control can be selected. If AUTO is selected, the brightness
of ZD display is adjusted automatically depending on the outside light.
By connecting ZDs to the control unit and using AUTO control, the illumina-
tion of ADVANCE CR and BF gauges is controlled automatically.
ADVANCE CR: Turned ON/OFF automatically
ADVANCE BF: Adjusted automatically

7 -3-4. Differential Pressure Display

If both of the turbo and the fuel pressure gauge are installed (both of the
turbo and fuel pressure sensors are installed in case of ZD), the fuel pressure
gauge can read the differential pressure value between fuel pressure and
intake manifold pressure. During Real mode, the indicator of DIFFERENTIAL
PRESSURE on the switch unit is lighted up in blue. The differential pressure can
be displayed in Record Mode as well.

1. Set the slide switch to

2. If the

button and

button are pressed at the

same time, the fuel pressure gauge displays the differential pressure and the
indicater of DIFFERENTIAL PRESSURE on the switch unit is lighted up. To can-
cel, press

button and

button together again.

7 -4. Setting number of cylinders mode (slide switch position :

)

When the tachometer is installed, please set the number of cylinders.
factory default setting: 4 cylinder

If ZDs are installed as well, settings for tachometer need to be done in Sys-
tem Setup Mode of ZD. The settings of ZD are applied to other tachometers
connected to the ADVANCE System. Refer to ZD manual for setting.

1.Set the slide switch to

2.When the

button is pressed long, the gauge shifts to Setting

number of cylinders mode, and warning and peak LEDs on the gauge blink

　alternately.

If ZDs are installed, the system moves into System Setup Mode of ZD not
tachometer setting mode. LEDs on the gauge doesn't blink. When the
tachometer is not installed, the system does not shift to Setting number of
cylinders mode.