BNC 835-M User Manual

Page 44

Model 835-M Programmer’s Manual V1.1 2011

TRIGGer[:SEQuence]:RETRigger ON|OFF|IMMediate

TRIGGer[:SEQuence]:RETRigger?

This command enables or disables the ARB retriggering mode; the retrigger mode controls how the
retriggering function performs while a waveform is playing.

ON (1) This choice specifies that if a trigger occurs while a waveform is playing, the

waveform will retrigger at the end of the current waveform sequence and play once
more.

OFF (0) This choice specifies that if a trigger occurs while a waveform is
playing, the trigger will be ignored.

IMMediate This choice specifies that if a trigger occurs while a waveform is
playing, the waveform will reset and replay from the start immediately upon
receiving a trigger.

*RST ON

:TRIGger[:SEQuence]:ECOunt
TRIGGer[:SEQuence]:ECOunt
TRIGGer[:SEQuence]:ECOunt?

This command sets a modulo on consecutive trigger events. Setting the value to N means that only
every Nth trigger event will be considered. Setting it to one means will use every trigger event that
does not occur during a running sweep.

*RST 1

Range 1 to 255

:TRIGger[:SEQuence]:OUTPut:POLarity
TRIGGer[:SEQuence]:OUTPut:POLarity NORMal|INVerted
TRIGGer[:SEQuence]:OUTPut:POLarity?

This command sets the trigger output signal polarity. Note that the trigger output must be

enabled by sending the [:SOURce]:LFOutput:SOURce TRIGger command.

*RST NORM

:TRIGger[:SEQuence]:OUTPut:MODE
TRIGGer[:SEQuence]:OUTPut:MODE NORMal|GATE|POINt This
command sets the trigger output signal mode.

NORMal The trigger output signal is pulsed once whenever playing a waveform

sequence is triggered.

GATE The trigger output signal is set when playing a
waveform sequence is triggered, and reset when playing stops.

POINT The trigger output signal is pulsed for each point of the sweep (list)

playing.

Note that the trigger output must be enabled by sending the [:SOURce]:LFOutput:SOURce

TRIGger command.

*RST NORM