BNC 835-M - Manual (Page 25)

25
Model 835-M Programmer’s Manual V1.1 2011
[SOURce]:PHASe Subsystem
Command Parameters Unit
(default)
Remark
[SOURce]:PHASe:REFerence V0.4.1
[SOURce]:PHASe[:ADJust] 0 radians V0.4.1
:PHASe:REFerence
[SOURce]:PHASe:REFerence
This command sets the current output phase as a zero reference. Subsequent phase adjustments are set
relative to the new reference.
:PHASe[:ADJust] [SOURce]:PHASe[:ADJust]
[SOURce]:PHASe[:ADJust]?
This command adjusts the phase of the signal. The query will only return values in radians.
*RST The preset value is 0.