BNC 835-M - Manual (Page 28)

28
Model 835-M Programmer’s Manual V1.1 2011
[SOURce]:ROSCillator Subsystem
Command Parameters Unit
(default)
[SOURce]:ROSCillator:EXTernal:FREQuency 10 MHz
[SOURce]:ROSCillator:LOCKed?
[SOURce]:ROSCillator:OUTPut:STATe ON|OFF|1|0 OFF
[SOURce]:ROSCillator:SOURce INTernal |
EXTernal
INT
: EXTernal:FREQuency
[SOURce]:ROSCillator:EXTernal:FREQuency
[SOURce]:ROSCillator:EXTernal:FREQuency?
This command conveys the expected reference frequency value of an externally applied reference
the signal generator. The variable is expressed in units of MHz.
*RST 10 MHz
Range 1 to 250 MHz
: LOCKed?
[SOURce]:ROSCillator:LOCKed?
This command queries if the synthesizer is locked to the externally applied reference.
:OUTPut:STATe [SOURce]:ROSCillator:OUTPut:STATe
ON|OFF|1|0 [SOURce]:ROSCillator:OUTPut:STATe?
This command enables or disables the 10 MHz frequency reference output.
*RST OFF
: SOURce
[SOURce]:ROSCillator:SOURce INT | EXT
This command selects either an internal or external reference for the waveform clock.
*RST INT