Fast & Fluid HA600 - Manual (Page 23)

FAST & FLUID MANAGEMENT
HA200 / HA400 / HA600 - V1.71 – 21-07-2004
IV OPERATION
page 23
Operation
A - First time operation
Step 1 Switching ON the dispenser & computer
>
Unlock the emergency stop button on the front of the machine by
turning clockwise. The machine is automatically switched on
when the power connector at the back of the dispenser is
plugged into a 220V or 100V-110V wall socket.
Please be aware that the Harbil series dispensers are fitted with
sleeping timers as standard. This means that after approximately
30 minutes the dispenser will enter a power saving modus in
which all secondary units (e.g. sensors) are switched off
automatically. Stirring is not affected by this modus.
To awake the dispenser from its sleeping modus, perform any
command from the dispensing software or press either of the
can table buttons.
Step 2 Switching OFF the dispenser & computer
>
Please note that with normal operation there should be no
reason to take the power off the dispenser. In case the
dispenser must be switched off, there are several ways of
achieving this:
1) Shut down the computer and unplug the power connector at
the back of the machine.
2) Shut down the computer and switch the internal power
socket behind the bottom service panel at the front of the
machine.
3) Shut down the computer and press the emergency stop
button.
Attention! Switching off the dispenser with the emergency stop will also
stop colorant agitation.
Step 3 Setting the stirring time
>
The stirring time and interval can be altered from its default
settings*. This can be done through the dispenser software,
check your software manual for instructions.
Please ask your paint supplier for optimal agitation settings for
your specific colorant products.
*
Default value is 180 seconds of agitation every 3 hours.