Fast & Fluid HA600 - Manual (Page 17)

FAST & FLUID MANAGEMENT
HA200 / HA400 / HA600 - V1.71 – 21-07-2004
II SAFETY INSTRUCTIONS
page 17
A - General safety instructions
Attention! Before installing the equipment and setting it in operation,
please read the instructions for use carefully. This is safer for yourself
and prevents unnecessary damage to the machine.
The manufacturer accepts no liability if the instructions below are not followed:
1. If a machine has been damaged (during transport, for example), do not attempt to set it in
operation. When in doubt, first contact either your supplier or the F&FM service department.
2. The equipment should be positioned and connected up in strict accordance with the
installation instructions.
3. All local safety regulations and ordinances should be observed.
4. The machine may be connected only to a 230V/16A/50Hz or 100-110V/25A/50-60HZ
earthed wall socket installed in accordance with the regulations.
5. Users should see to it that the machine is kept in good condition. Defective components
should be replaced.
6. In order to prevent physical injury, the doors should be closed and the paneling fitted during
normal use.
7. All service activities (other than routine maintenance and adjustments) may only be carried out
by qualified technicians. See to it that the mains lead is always kept unplugged while repairs
are being carried out.
8. Because of the design of the valve, a nozzle drill may never be used. Cleaning is done by
running the cleaning program.
B - Specific warnings in this manual
Attention! Switching off the dispenser with the emergency stop will also
stop colorant agitation.
Attention! The punch knife is very sharp! Do not hold can while punching.
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power
(e.g. by pressing emergency stop) before accessing moving parts.