Fast & Fluid BT-Tintmaster - Manual (Page 8)

4 Positioning/Installing the machine 6
4.1 Conditions for correct positioning
Make sure that the following requirements are met when positioning the machine:
•
Place the machine on a stable, flat surface, and make sure that it is level.
•
Any dry, well ventilated place is suitable. The machine should preferably not be placed in the
sun or near a radiator or other source of heat, since this can cause the pastes to dry out.
•
Maintain a constant ambient temperature of approximately 18
o
C to prevent viscosity changes in
the pastes.
•
Make sure that the machine is connected only to a 230 V / 50 Hz / 60 Hz earthed wall socket.
4.2 Installing the machine
4.2.1 Preparation
Note: Tools and fastenings are supplied with the machine. They include spanners, cable connectors,
bolts, washers etc.
•
Remove the plastic bag of lids and the installation kit from the lift table. Take the spanner out of the
installation kit and remove the side panel on the left side of the machine.
•
Remove the fastening bolts attaching the machine to the pallet (see figure 1, number 1).
•
Turn the adjustable feet at the front of the machine(see figure 1, number 2) all the way up.
•
Remove the wooden slat from under the machine.
figure 1
1 3 2