Fast & Fluid BT-Tintmaster - Manual (Page 13)

5 Operation 11
5.2 Starting the machine
5.2.1 Preparing the machine for use for the first time
1. Turn the red main switch (see figure 10, number 1) to position .
You are advised to leave this switch turned on at all times. This is necessary for the automatic
stirring system. It also reduces wear on the machine and the computer system.
Then turn also the green switch (see figure 10, number 12) to position . Now the computer is
turned on. Switch the computer off at the end of the day.
2.
Open the door of the machine and remove the brush tray. Fill the brush tray with water or a
diluted detergent (under no circumstances use a solvent!) up to the level mark. Replace the tray
in the correct position and close the door.
3.
Use the software to set the stirring interval*.
4.
Adjust the thermostat if installed (see the instructions for use supplied with the thermostat).
5. Fill the canisters with paste up to the indicated maximum level* by opening the flap and removing the
lid of the canister. The canister can now be filled to the top of the upper stirrer. Make sure that the
piston rod remains at the same height.
6.
Ask your paste supplier for the stirring data for the pastes. It may be necessary to stir the pastes.
Stirring can be started with the aid of the software*.
7.
Now you can start the morning program*.
5.2.2 Preparing the machine at the start of the day
1. Open the door of the machine and remove the brush tray. Fill the brush tray with water or a
diluted detergent (under no circumstances use a solvent!) up to the level mark. Replace the tray
in the correct position and close the door.
2.
If necessary, top up the canisters to the maximum level. When you do this it may be necessary
to stir the pastes (ask your paste supplier).
3.
Start the morning program*.
The machine is now ready for the day.
*
see software manual