Fast & Fluid BT-Tintmaster - Manual (Page 14)

6 Maintenance 12
6.1 Maintenance instructions
Always remove the power cord from the mains socket before commencing any maintenance
work on the machine.
1. Servicing and repairs may only be carried out by qualified personnel
2.
Use good quality, appropriate tools only.
3.
Use original Fluid Management parts only.
4.
Before the machine is made available for use after service, all settings must be checked to
ensure that they are correct and the operating and safety systems must be checked to ensure
that they are functioning properly.
6.2 Maintenance to be carried out by the operator
Daily :
1. Clean the cleaning brush and replace the cleaning fluid in the brush tray (see 5.2.1, point 2).
2.
Check nozzles for blockage by means of the morning program*. If there is a blockage, contact
the Service Department (see 6.4).
Weekly :
1. Remove spilt paste from the turntable and lift table.
2.
Check the content of the canisters and top up to the indicated level. Update the content data
stored in the computer*.
Monthly :
1. Clean the computer cavity, the computer can be affected by dust.
2.
Check the valves, valve housings and pumps for leaks..
3.
Check that the valve handle is still in the correct position.
*
see software manual