ARB 3468010 - Manual (Page 15)

Last Rev Date: 14 05 08 Page 15 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
41. Drill two new 13mm holes in the roller
fairlead provided in the kit, as shown on
the adjacent
picture.
42. Place roller fairlead over lower holes
and again secure using 3/8” hardware (1
¾”x 3/8” bolts) flat and spring washers.
43. Using circlip pliers, remove lower
circlips and push shaft upwards to be
able to move rollers sideways.
44. Fit number plate bracket to bar using
6mm hardware.
45. Using screwdriver move vertical
rollers sideways and tighten all bolts
using socket and extension.
46. Refit rollers and circlips.
Use new drill holes to bolt to bar.