ARB 3468010 - Manual (Page 14)

Last Rev Date: 14 05 08 Page 14 of 21 Fitting instructions# 3786403
Copyright © 2005 by ARB Corporation Limited. All rights reserved, thi s document must not be reproduced without the express authority of ARB Corporation Ltd
38. To fit control box to bar, you must
change the arrowed lead (yellow tagged
) in photo with the longer lead that is
supplied in fitting kit. When all is fitted,
screw plastic cover back onto control
box.
39. To fit winch into bar you must pack
winch up on a bench to enable you to
lower bar down on winch, then fit four
3/8 ” square nuts into winch lugs .
40. Lower bar down over winch, line up
top holes first and secure using 3/8”
hardware (1 ½”” x 3/8”bolts) flat and
spring washers. ( finger tighten only )