ARB 3432150 - Manual (Page 20)

19-03-08 Page 20 of 21 3783182
WASHER BOTTLE GUARD FITMENT TO BULL BAR
71. Fit the washer bottle guards to both sides
of the bull bar .
72. Use the three M6 x 20mm black bolts, M6
black flat washers and M6 black spring
washers to attach the guards to the wing
along the front and side edges .
73. Attach the M8 x 20mm black bolt , M8
black flat washer and M8 black spring
washer to attach the guard to the impact
absorber as shown .
74. On the right hand side of the vehicle ,
Push the out side edge of the fender liner
forward and tuck it in behind the outer
edge of the washer bottle guard .
Using a paint marker mark the upper and
lower holes ( through the guard onto the
fender liner ) .
Repeat the marking of the holes on the
Left hand side of the vehicle.
75. Using a 8 mm drill bit - drill the upper and
lower hole in the right hand side fender
liner .
76. With both the upper and lower holes
marked on the Left hand side , pull the
fender liner rearward – clear of the
washer bottle guard and drill the holes.
WARNING :- DO NOT DRILL THE
LEFT HAND FENDER LINER HOLES
IN PLACE AS THE WASHER BOTTLE
WILL BE PUNCTURED .