Off Road Unlimited 60013 2001-08 GM 2500-3500 HD 4WD 4-Link Coil-Over w/Solid Axle Conversion Kit User Manual

Page 19

ORU- GM 4 Link Coil-Over Conversion Kit #60013

Part Four: Transmission Cross-Member and Link Installation-

15) Drain the transmission and transfer case fluid into a suitable container. Support the transmission at
the pan area. Be careful not to damage the pan.

16) Re-install modified transfer case. NOTE: The transfer case modification (steps #55-62) and re-
installation MUST be done prior to step #17!

17) Remove the factory transmission cross member.

18) Remove the exhaust "Y" pipe and frame heat shield that is secured with 2 bolts on passenger side.

19) Drill the (2) factory exhaust heat shield mounting holes on the inside of the frame to 7/16". Drill the
same holes on the driver side out to 7/16" (photo 15).

Photo 15

20) Install #60013-11 (driver side) & 60013-12 (pass. side) frame support brackets at inside of frame
using 7/16" x 1" bolts with flat washers and lock nuts (photo 16). Using bracket as a template, mark (2)
holes on outside of frame, drill to 7/16" and install 7/16" x 1" bolts with flat washers and lock nuts
(photo 17).

Photo 16

offroadunlimited.com

page 18

7/16"
hole