JLG 534D-10 Parts Manual - Manual (Page 48)

534D-9/534D-10 91344005 2-8
BOOM
Figure 2-2 Second Boom Section
NOTES:
1. ADD BEARING PAD, SHIMS & SPACERS AS REQUIRED TO SHIM BOOM TO WITHIN 1/16 IN
OF A TIGHT FIT. AMOUNTS OF SHIMS CAN VARY AT EACH SHIM POINT. WHENEVER A SHIM
IS USED WITH A PAD, A SPACER MUST BE INSERTED BETWEEN PAD & SHIM. NO PADS
SHALL SIT DIRECTLY ON SLOTTED SURFACE OF SHIMS.
2. ADD, 14404793, GREASE TO ALL BEARING PADS & BEARING SLIDE AREAS. INCLUDING
INSIDE OF PUSH BEAM WHERE CROWD CYLINDER PADS SLIDE.
3. THE LENGTH OF PAD BOLTS DEPEND ON THE AMOUNT OF SHIMS USED. BOLT CANNOT
EXTEND PAST CHAMFER ON BEARING.
4. BEARING PAD TORQUES, 3/8 IN BOLTS = 32-37 ft.lbs. & 1/2 IN BOLTS = 76-86 ft.lbs.
45 FT BOOM
534D-9 S/N 0644119 & After
534D-10 S/N 0366089 & After