Hale Fyr Pak(2006 to Present) - Manual (Page 7)

Fyr Pak
Operation and Maintenance Manual
7
OPERATION AND INSTRUCTION MANUAL FOR ENGINE DRIVEN,
BACKPACK CENTRIFUGAL PUMPING UNIT
Introduction
PURPOSE
This operation and instruction manual is published to guide and assist in the installation, operation, lubrication,
maintenance, and repair of the Hale FYR PAK pumping unit. The installer and operator should understand this
manual before attempting to install or operate the unit.
IDENTIFICATION
Whenever a question arises regarding your pumping unit, contact your Hale Dealer for the latest available
information. This dealer will also be able to advise you of the nearest authorized engine dealer who can provide
service for the engine in your pumping unit. Finally, if additional help is needed, contact the Service Department
of Hale Products Inc.
Please supply the complete pump model and serial numbers when requesting information or ordering parts.
The pump model and serial numbers are stamped (not cast) on the Hale nameplate. For your convenience, fill
in the information on the Hale nameplate below.
Also always mention both the model number and serial number of your engine when ordering engine parts.
These numbers are found on the engine identification plate attached to the engine.
To help identify the pump parts used in your FYR-PAK, a pump parts catalog is included toward the back of this
manual. To identify the engine parts used in your pumping unit refer to the engine manufacturer’s parts catalog.
DESCRIPTION GENERAL
The FYR-PAK is a lightweight portable centrifugal pump mounted on a modern adjustable backpack frame.
It consists of a Hale type 20FP single stage, centrifugal pump close coupled to an air-cooled, 2-cycle, single
cylinder, engine overspeed control switch, priming pump and priming valve. The unit will deliver discharge
pressures to 220 PSIG and flows to 75 GPM from draft