Bosch VIDEOJET X40 - Manual (Page 52)

52 en | Configuration Using a Web Browser VideoJet X40
V3.5 | 2007.12 Installation and Operating Manual Bosch Security Systems
5.18.1 Creating a Partition
Creating a new partition is performed using separate windows in which information is
presented to you and you are led step by step through the necessary settings.
The process must be completed for each partition to be set up on the hard drive. After
startup, you can select the total number of partitions to be set up. The setup process is then
started as often as is necessary to configure all partitions.
1. Click the Create partition button to start the assistant for creating partitions. The first
window appears.
2. You should always first read the information text in the upper section of the window.
3. Click in the text fields to enter values or use the other controls that are available, such as
buttons, checkboxes or list fields.
4. Click the Next > button at the bottom of the window to continue with the next step.
5. Click the < Back button at the bottom of the window to view the previous step again.
6. Click the Cancel button to cancel the process and close the wizard.
5.18.2 Saving Changes
After you have made all necessary settings, you must transfer the settings to the unit and save
them.
i
NOTICE!
The maximum number of partitions is predefined and corresponds to the number of video
inputs on the unit.
You can create multiple partitions of the same type in one process. To do this, check the box
Apply same settings for all new partitions in the first window.
!
CAUTION!
All modifications to settings are only effective if you complete the configuration in the last
window by clicking Finish.