beautypg.com

10 picture settings, Picture settings – Bosch VIDEOJET X40 User Manual

Page 37

background image

VideoJet X40

Configuration Using a Web Browser | en

37

Bosch Security Systems

Installation and Operating Manual

V3.5 | 2007.12

5.10

Picture Settings

You can set the video image of each camera to suit your requirements. The current video

image is displayed in the small window next to the slide controls as confirmation. Your

changes are effective immediately.

1.

Click a tab to select the corresponding camera.

2.

Move the slide control to the required position.

3.

Click Default to reset all settings to their default value.

5.10.1

Contrast (0...255)

You can use this function to adapt the contrast of the video image to your working

environment.

5.10.2

Saturation (0...255)

You can use this function to adjust the color saturation so as to make the reproduction of

colors on your monitor as realistic as possible.

5.10.3

Brightness (0...255)

You can use this function to adapt the brightness of the video image to your working

environment.

5.10.4

Low-pass filter (0...255)

You can use this function to filter very fine noise from the image. This reduces and optimizes

the bandwidth necessary for image transmission over the network. The image resolution may

be impaired.

The higher the value set with the slide control, the flatter the image signal. Check your setting

in the image window next to the slide controls.

Also observe the processor load indicator that appears at the top of the window near the

manufacturer's logo (see Section 8.5 Processor Load, page 115).