Brother SC-2000 - Manual (Page 7)

5
SET UP
Machine Mode Operations
The Stampcreator Pro has different modes for performing different operations.
Follow the operations described below to select the desired mode.
Initializing the machine
• Turn the machine off, then on again to initialize it. The message “INITIALIZE” appears in the LCD.
• When data has been cleared, the message “READY” appears in the LCD.
Removing the draft sheet and clearing data
• Press the Mode button once until “RESET” appears in the LCD.
• Press the Set button (see page 44).
Periodic machine cleaning
• Press the Mode button twice until “CLEAN” appears in the LCD, and then insert a cleaning sheet.
• Press the Set button (see page 48).
Resetting the xenon lamp counter
• Reset the counter only after the xenon lamp unit has been replaced with a new one.
• Press the Mode button four times until “RESET COUNTER” appears in the LCD, and then install a new xenon
lamp unit.
• Press the Set button (see page 49).
Baud rate
The baud rate of the machine must match the baud rate of the Stamp Editor software. A larger number will give you faster
data transmission.
System Requirements
Computer requirements
Check that your system meets the following requirements.
• IBM PC or compatible 486DX or faster (Pentium ® 100 MHz recommended)
• Microsoft Windows ® 98, 98SE, Me, NT 4.0, 2000 Professional, XP Professional, or XP Home Edition
• Available hard-disk space: Minimum 70 MB
• Available memory: Minimum 64 MB
• VGA or higher graphic card
• Port: COM port (9-pin RS-232C serial port that supports 57,600 bps)
Parallel port (25-pin parallel port (LPT port))
• CD ROM drive
• Pointing device