Philips HTS3541-F7 - Manual (Page 22)

20 EN
6 Update software
Philips continually tries to improve its products.
To get the best features and support, update your
home theater with the latest software.
Compare the version of your current software with
the latest version on www.philips.com/support. If
the current version is lower than the latest version
available on the Philips support website, upgrade
your home theater with the latest software.
Caution
• Do not install a lower version of software than
the current version installed on your product.
Philips is not liable for problems caused due to
software downgrade.
Check software version
Check the version of the current software installed
on your home theater.
1
Press ( Home ).
2
Select [Setup] , and then press OK .
3
Select [Advanced] > [Version Info.] , and then
press OK .
» The software version is displayed.
Update software through USB
What you need
• A USB fl ash drive that is FAT or NTFS-
formatted, with at least 75MB of memory. Do
not use a USB hard drive.
• A computer with Internet access.
• An archive utility that supports the ZIP fi le format.
Step 1: Download the latest software
1
Connect a USB fl ash drive to your computer.
2
In your web browser, go to www.philips.com/
support.
3
At the Philips Support website, fi nd your
product and locate the Software and drivers .
» The software update is available as a zip fi le.
4
Save the zip fi le in the root directory of your
USB fl ash drive.
5
Use the archive utility to extract the software
update fi le in the root directory.
» The fi les are extracted under the UPG_
ALL folder of your USB fl ash drive.
6
Disconnect the USB fl ash drive from your
computer.
Step 2: Update the software
Caution
• Do not switch off the home theater or remove
the USB fl ash drive during the update.
1
Connect the USB fl ash drive containing the
downloaded fi le to your home theater.
• Make sure that the disc compartment is
closed and no disc inside.
2
Press ( Home ).
3
Select [Setup] , and then press OK .
4
Select [Advanced] > [Software Update] > [USB] .
5
Follow the onscreen instructions to confi rm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.
Update software through the
Internet
1
Connect your home theater to a home network
with a high-speed Internet access (see 'Connect
and set up a home network' on page 10 ) .
2
Press ( Home ).
3
Select [Setup] , and then press OK .
4
Select [Advanced] > [Software Update] >
[Network] .
» If an upgrade media is detected, you are
prompted to start or cancel the update.
5
Follow the onscreen instructions to confi rm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.