Philips FWC555 - Manual (Page 11)

First Time Setup 11
Where to Start
1 Put the batteries in the remote control and connect the
AM and FM antennas as detailed below.
2 Connect the speakers to the system as detailed in your
Quick Use Guide (or on page 10).
3 Plug in the system.
4 Install or exit Plug & Play.
● Follow the on screen instruction to install Plug & Play.
● Press 7 to exit Plug & Play without installing.
Battery Installation
1 Remove the battery compartment lid by pressing in the
tab, then lifting off the lid.
2 Place the batteries in the battery compartment, match-
ing the +/- markings on the batteries to the +/- markings inside
the remote.
3 Replace the battery compartment lid.
Antenna Connections
1 Connect the supplied AM loop antenna to the AM jack on
the rear of the system.
● Reposition the loop antenna to receive the clearest sound for
area stations. Attach the antenna to the base stand if desired.
2 Connect the supplied FM antenna to the FM jacks on the
rear of the system. Extend and adjust the antenna until the
clearest station signal is received.
Put the claw
into the slot.
1
2
3