B&B Electronics Network Device I-7011 User Manual
B&B Electronics Hardware
Table of contents
Document Outline
- Table of Contents
- 1. Introduction
- 1.1 More Information
- 1.2 Pin Assignment
- 1.3 Specifications
- 1.4 Block Diagram
- 1.5 Wire Connection
- 1.6 Quick Start
- 1.7 Default Setting
- 1.8 Jumper Setting
- 1.9 Calibration
- 1.10 Configuration Tables
- 2. Command
- 2.1 %AANNTTCCFF
- 2.2 #**
- 2.3 #AA
- 2.4 #AAN
- 2.5 $AA0
- 2.6 $AA1
- 2.7 $AA2
- 2.8 $AA3
- 2.9 $AA4
- 2.10 $AA5VV
- 2.11 $AA6
- 2.12 $AA8
- 2.13 $AA8V
- 2.14 $AA9(Data)
- 2.15 $AAB
- 2.16 $AAF
- 2.17 $AAM
- 2.18 $AAZ(Data)
- 2.19 ~AAO(Data)
- 2.20 ~AAEV
- 2.21 @AADI
- 2.22 @AADO(Data)
- 2.23 @AAEAT
- 2.24 @AAHI(Data)
- 2.25 @AALO(Data)
- 2.26 @AADA
- 2.27 @AACA
- 2.28 @AARH
- 2.29 @AARL
- 2.30 @AARE
- 2.31 @AACE
- 2.32 ~**
- 2.33 ~AA0
- 2.34 ~AA1
- 2.35 ~AA2
- 2.36 ~AA3EVV
- 2.37 ~AA4
- 2.38 ~AA5PPSS
- 3. Application Note
- 3.1 INIT* pin Operation
- 3.2 Module Status
- 3.3 Dual Watchdog Operation
- 3.4 Digital Input and Event Counter
- 3.5 Digital Output
- 3.6 High/Low Alarm
- 3.7 Thermocouple Measurement