B&B Electronics Network Device I-7011 - Manual (Page 39)

39
I-7011, I-7018 User Manual Rev:B1.0
2.18 $AAZ(Data)
Description : Set LED Data
Syntax : $AAZ(Data)[CHK](cr)
$ delimiter character
AA address of setting module (00 to FF)
Z command for setting LED data
(Data) data for show on the LED, from -19999. to +19999. The
data need sign, 5 digits and decimal point.
Response : Valid Command : !AA[CHK](cr)
Invalid Command : ?AA[CHK](cr)
Syntax error or communication error may get no re-
sponse.
! delimiter for valid command
? delimiter for invalid command or LED not set to host
control
AA address of response module (00 to FF)
Example :
Command : $01Z+123.45 Receive : !01
Send address 01 LED data +123.45, return success.
Command : $02Z+512.34 Receive : ?02
Send address 02 LED data +512.34, return the LED is not
setting in the host mode.
Related Command :
Sec.2.12 $AA8, Sec2.13 $AA8V
Note : The command is for I-7011D/11PD only